1/16 Herbie Goes to Monte Carlo Decals; Movie Accurate, Rides Again, VW Beetle

Description

MOVIE ACCURATE Herbie The Love Bug decals for your 1/16 scale beetle.
(a lighter blue is available on the Herbie the Love Bug listing)
I was building a Herbie, and needed decals. Every decal set I could find was the wrong font, the wrong size, or wrong in some other way.
These are scaled to be 1/16 from real sized
What is included;
Accurate "53" font.
at least 6  round 53gumballs
at least 2  round 90% sized 53gumballs which may work better on the rear hood of some VW bodies.
at least 2  oblong 53 gumballs which may work better on the frunk. The actual movie cars usually had the 5 and 3 further apart here due to the trim, and I have done the same.
at least 4  racing stripes.
at least 3 blank white circles. These should not be needed, but can be used to prevent any color bleed through to the gumballs.
at least 2 Rag top roof decals. 1 blank. The other includes a stripe that should run from windshield to rear window (it may be too long or too short depending upon your body, but that's why I include stripes)
at least 2 movie accurate license plates without tabs.
at least 2 sets of Love Bug racing tape decals for headlights
Herbie Goes to Monte Carlo Trance France Race rear window decal
Herbie Goes to Monte Carlo Trance France Race front window decal
Herbie Goes to Monte Carlo mock fuel door (this one is VERY low quality compared to the other decals, and is still a work in progress).
Herbie Goes to Monte Carlo Carello Fog/Driving light cover decals.
Listed decals will all be pre-cut. Just peel and stick.
in addition, extra decals will be usually be included based upon supply. it's always nice to have spares, or to match your controller to your car.
(extra decals may not be pre-cut, but should be easy to self cut).
Full scale number gumballs are about 16"
Movies have the stripes varying between 5 1/2" - 6 1/2".
Decals are peel and stick and printed on a vinyl laminated paper. Which are water resistant but not waterproof.
If you need waterproof (ie for a boat) contact me.
If you'd prefer waterslide contact me, though I will be out of material until July of 2021 and they will not be precut.
The decals received will be printed with a "print bleed" effect, which will make the sheet look different than the photo by over printing around the cuts, but should only improve the quality of the sticker.